I have extra 1” prop spacer, 3/8 crush plates etc

[ykachuro]

I was fitting my prop and needed a 1” prop spacer, 3/8 crush plate and 1/8 spacer. I didn’t like the offerings from the usual suspects and had it custom CNC machined to my liking out of 6061 T6 aluminum. Since the CNC setup cost is the biggest component, I had some extra pieces made to spread the cost. All made to precision tolerances and close interference fit.

If interested, I have a couple of extras of each of the following:

1” prop spacer, 1/2” bolt SAE2 pattern, 7” wide on the side facing the prop, 6 3/8” on the crankcase side (to match the starter ring flange diameter) — $275

3/8 crush plates in 1/2” and in 7/16” bolt SAE2 patterns, 7” diameter $55

3/8 crush plate in 3/8” bolt SAE1 pattern $50

1/8 spacer in 1/2” and in 7/16” bolt SAE2 patterns, 7” diameter $27

1/8 spacer in 3/8” bolt SAE1 pattern $22

All prices include shipping in the lower 48.

A picture of the 1/2 bolt patern spacer, crush plate. Pls let me know if you’d like to see more pics

ykachuro at gmail dot com