Page 1 of 1
Re: Canopy — right side “closer angle”
Posted: Fri Jul 02, 2021 5:14 pm
by at7000ft
ykachuro wrote: ↑Sat Jun 27, 2020 10:55 pmThank you!
Has been 4 years and no one has yet posted a picture of the canopy frame closer angle installed? Does the short side of the angle point up or down?
Thanks
Re: Canopy — right side “closer angle”
Posted: Sat Jun 27, 2020 10:55 pm
by ykachuro
Thank you!
Re: Canopy — right side “closer angle”
Posted: Sat Jun 27, 2020 7:27 pm
by fwellman@att.net
Its been such a long time since I did the canopy that I don't recall if I used that thin sheet metal angle or not. A lot of people leave it out and fill the space with a strip of rubber window insulation like the kind you buy at Home Depot that has sticky tape on one side. I will pull my canopy off of the shelf on Monday and take a look. Ill send a pic then.
Re: Canopy — right side “closer angle”
Posted: Sat Jun 27, 2020 3:03 pm
by ykachuro
From the BM “fitting bubble skirt to frame:”
30.Install the closer angle as shown between hinges on the right side. We use 3 M body adhesive tape for nice appearance, but it can be installed with rivets if desired.
“as shown” is not shown in the BM
Thanks!
Re: Canopy — right side “closer angle”
Posted: Sat Jun 27, 2020 9:45 am
by fwellman@att.net
Can you be more specific?
Canopy — right side “closer angle”
Posted: Wed Jun 10, 2020 5:53 pm
by ykachuro
I am having a brain fart (not an infrequent event). Could anyone take a picture of how the “closer angle” should be positioned? The one that is supposed to go between the hinges on the right side.
Thanks!