Page 1 of 1
Re: Want AD46H Rivets
Posted: Thu Mar 29, 2018 1:45 pm
by RonFranck
Thanks much, Dan!
Re: Want AD46H Rivets
Posted: Wed Mar 28, 2018 8:19 pm
by PlaneDan
These are not AD46H. The label that I have for them is PR46ASPH Steel Closed and I have all you need. Send your address to
Danrh@Windstream.net and I will get them out to you tomorrow. NO COST.
Want AD46H Rivets
Posted: Wed Mar 28, 2018 4:58 pm
by RonFranck
I need 16 of the -46 length closed end rivets to install my fuel drain flanges in the gas tanks.
I can get them from Spencer Aircraft but unfortunately $2.50 cents of rivets shipped for $8.85 cents
seems a bit silly. If I had something else to order to soften the shipping cost I'd do so, but Ii don't know of anything I need right now and alone that much for shipping is a bit uncomfortable.
I'm tempted to use a standard BSP-46 open end rivet and just make sure I use a lot of Proseal on each one, but I'm not quite there yet.
Does anyone have any extras they are willing to sell?
Ron