Want AD46H Rivets

Off topic discussion board
Forum rules
A forum for Panther aircraft builders and Enthusiasts. Two simple rules: Play nice and use a real name
Post Reply
User avatar
RonFranck
Posts: 84
Joined: Sat May 25, 2013 7:55 am
First Name: Ron
Last Name: Franck
City or Town: Cambridge
State or Province: IL
Location: Cambridge, IL, USA
Contact:

Re: Want AD46H Rivets

Post by RonFranck »

Thanks much, Dan!

PlaneDan
Posts: 241
Joined: Sun Nov 17, 2013 11:52 am
First Name: Daniel
Last Name: Heath
City or Town: Lexington
State or Province: SC USA
Location: Lexington, SC USA
Contact:

Re: Want AD46H Rivets

Post by PlaneDan »

These are not AD46H. The label that I have for them is PR46ASPH Steel Closed and I have all you need. Send your address to Danrh@Windstream.net and I will get them out to you tomorrow. NO COST.
PantherBuilder.org

User avatar
RonFranck
Posts: 84
Joined: Sat May 25, 2013 7:55 am
First Name: Ron
Last Name: Franck
City or Town: Cambridge
State or Province: IL
Location: Cambridge, IL, USA
Contact:

Want AD46H Rivets

Post by RonFranck »

I need 16 of the -46 length closed end rivets to install my fuel drain flanges in the gas tanks.
I can get them from Spencer Aircraft but unfortunately $2.50 cents of rivets shipped for $8.85 cents
seems a bit silly. If I had something else to order to soften the shipping cost I'd do so, but Ii don't know of anything I need right now and alone that much for shipping is a bit uncomfortable.
I'm tempted to use a standard BSP-46 open end rivet and just make sure I use a lot of Proseal on each one, but I'm not quite there yet.
Does anyone have any extras they are willing to sell?
Ron

Post Reply