Page 3 of 5
Re: Prime and Paint
Posted: Sun Jun 15, 2025 6:22 pm
by xtricity
Re: Prime and Paint
Posted: Sun Jun 15, 2025 6:12 pm
by xtricity
Re: Prime and Paint
Posted: Sun Jun 15, 2025 6:02 pm
by xtricity
Re: Prime and Paint
Posted: Sun Jun 15, 2025 5:51 pm
by xtricity
Re: Prime and Paint
Posted: Sun Mar 16, 2025 10:30 pm
by monclerjacket
Re: Prime and Paint
Posted: Sat Feb 13, 2016 8:11 am
by Greg Pixley
It's an Acrylic Urethane applied over DP50LF Epoxy primer. And your right about Niceville, never thought I'd end up here but it was a great place to raise kids and retire.
Re: Prime and Paint
Posted: Mon Feb 08, 2016 12:36 am
by Lowrider
Greg,
Is that PPG an epoxy paint or primer? I used to live in Niceville when I was a charter member of the 1st SOW...good place to be!!
Re: Prime and Paint
Posted: Sun Feb 07, 2016 5:02 pm
by Greg Pixley
I just finished painting the floor and side panels with Shopline (PPG) and can't tell the difference from powder coat. The color was #34615 #4 Medium Gray. All my painting experience is with PPG so I stayed with what I know and have reducers for. A quart was $60 with hardener but I only used a quarter of that.
Greg Pixley
Re: Prime and Paint
Posted: Mon Oct 19, 2015 9:08 pm
by Steamer
Glen,
I've had that happen with rattle cans. In my experience it was because the paint had set on the shelf too long.
Stan J.
Re: Prime and Paint
Posted: Mon Oct 19, 2015 7:28 pm
by GlenNJ
Mike,
I'll order a couple of cans and give them a try. I'm working on the spars, and I'd like to put a thin mist coat on the pieces. I can't do that with the Moeller chromate, the way it spits and splatters out of the can. All 4 cans I've used did the same thing, from beginning to end of the can.
Glen