Nameplate Engravings

Topics about finishing touches
Forum rules
A forum for Panther aircraft builders and Enthusiasts. Two simple rules: Play nice and use a real name
Post Reply
Posts: 12
Joined: Tue Jun 12, 2018 8:42 pm
First Name: Rick
Last Name: Gamble
City or Town: Murfreesboro
State or Province: Tn

Nameplate Engravings

Post by Rickifly »

I created a few nameplate/engravings that are being worked on by Aircraft Engravers out of CT. Good crew, but a little expensive if you make them to complex which takes more hours to produce. They are only .020" thick v. .065" and up, so cost is more.

The 1st nameplate is the typical side wall mounted plate that shows Trim/Throttle and Mixture. If you chose the standard BM quadrant this will work for you too.

The other three nameplates are specific to my Instrument panel layout but includes information that may be used in your own layout.

DXF Files are available by DM.
If anyone wants me to do a nameplate file, I am offering drafting services, just DM me.
You do not have the required permissions to view the files attached to this post.

Post Reply